![]() Why does my MP3 export as Stereo, when I am recording in Mono?įirst make absolutely sure that you have set your recording preferences as Mono in Edit | Preferences | Devices | Recording | Channels, and that you have selected Joint Stereo as the Channel mode in the Options when you export the MP3. Recording in Mono just instructs Audacity to apply the same content to both left and right. ![]() When you export the file it will end up playing back in Stereo. Since most of us don't use Stereo microphones, choose Mono. Go here for the -> Audacity Noise Cleaning TutorialĪudacity allows you to choose Stereo or Mono when you start your recording. Devorah Allen (mightyfelix) demonstrates how to use this method here Can I clean up background noise? This means that after you make a mistake you can stop recording and immediately re-record the flubbed line, without the need to edit out the mistake later. (You might want to look at Deleting Errors in Audacity, too.)Īlthough the above method is probably the easiest when first starting out, Audacity has the option to use the punch and roll method. Delete the selected portion of your recording.Select a portion of your recording to edit: Click and Drag.Result of tapping on microphone (or tongue click).Whatever method you use just makes it easier to see edit points. Other readers also say "pickup" or click their tongue. Do not tap the microphone itself as this can damage it. You can tap the microphone base a few times before re-recording so that it is easier to see where you need to make the edits. When you make mistakes it's usually easier to just re-record the section you want immediately. If you open this file in Audacity it would be easier to edit. This will create a new file which has only one track. If you would like to collapse all these tracks together you can choose File > Export to WAV. An AUP maintains all the tracks that you have from starting and stopping the recording. These aren't very useful for sharing, but it is a good intermediate format to use while you are editing. When you save in Audacity it creates an AUP (AUdacity Project) file. If you want to record on multiple tracks, hold down the Shift key while clicking the Record button. If you want to take a break and hit Stop (Yellow square), the next time you hit Record again it will start recording at the end of the track. example How do I Start Recording?Ĭlick the round red button to start recording. Use the same settings as above except you choose Stereo for Channels and mark the box labelled Software Playthrough. If you recorded on tape and want to transfer to your computer you can also use Audacity. Quality > select 128 kbps from the drop down menu.Bit Rate Mode > select the Constant radio button.Set the bitrate the first time you export to mp3 by going to:.Select the file, and click the OK button.Read the message, then click Yes and browse to wherever you installed the file lame_enc.dll. ![]() Now that you've installed the LAME encoder (see above), you need to integrate it into Audacity. How do I configure Audacity to find and use the LAME encoder plug-in? Quality > Default Sample Format: 16-bit.Quality > Default Sample Rate: 44100 Hz. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |